COMPANY HEADER
Request Information
Reduced-Tip, Flanged Thermowells are available in a variety of materials, flange types, flange sizes, and pressure ratings. They are also available in various lengths and with optional lagging extensions. Thermowell specifications should be determined based on process conditions which include strength, temperature, pressure and corrosion-resistance requirements. The stepped construction is normally used in standard-duty applications, and increases the speed of response while maintaining mechanical strength. They are designed with standard 0.260" bore diameters to accommodate sensing elements with a 0.252" maximum diameter. These wells are available as separate components or as part of complete sensor assemblies.
Unit of Measure

Specifications

Brands

 N/A Pyromation®

Well Type

 N/A Code RF - Reduced-tip Flanged

Bore Diameter

 N/A Code 4 - 0.260 in

Flange Size

 N/A Code 10 - 1 in. (DN 25) Code 13 - 1-1/4 in. (DN 32) Code 15 - 1-1/2 in. (DN 40) Code 20 - 2 in. (DN 50) Code 30 - 3 in. (DN 80)

Flange Type

 N/A Code F - Flat face Code J - Ring joint Code R - Raised face

Pressure Rating

 N/A Code 1 - 150 Class Code 15 - 1500 Class Code 3 - 300 Class Code 6 - 600 Class Code 9 - 900 Class

Note for Material

 N/A Specify two digit material code as stated in the Thermowell Material Table located earlier in section
Optional Lag Dimension (T)1 N/A Code T - Specify "T" dimension in inches

Note for "S" Length

 N/A Specify length in inches using two digits plus fractional length

Options

Options

 N/A Code C22 - Brass well cap and chain Code C8 - 316 Stainless steel well cap and chain Code F - Full penetration weld Code S - Well stamped with customer-specified part number

Additional Information

Additional Information

 N/A ("U" length for non-lagging wells) = "S" - 2"
("U" length for lagging wells) = "S" - 2" - "T"
(To solve for "T"), "T" = "S" - "U" - 2" (When "U" and "S" are specified)
  • 1 Leave blank if no lag is required